What are the basic requirements for the configuration of a good price and quality Intelligent automatic shoe production line?

1. Ancillary equipment: toe cap shaping machine, back bell shaping machine, vamp softening machine, back eye steaming machine;

2. Requirements for the board room: the upper angle of the manual board is larger than that of the machine. First, it is a waste of raw materials; The machine board requires moderate material cutting, especially for high whip surface warping.

3. Supporting shoe materials: Whether the midsole exceeds the shoe last, if so, trim it with scissors or slightly smaller than the toe part. For special toe caps with large warping, use white glue on the midsole toe part before the upper. Or the double-sided tape sticks a little. In general, the midsole roughly matches the toe cap, and the surface has mesh silk floss to enhance the adhesion; the edge of the midsole and the corners of the upper are made of white latex. Moderate, too dry and too wet will have a great influence on the knotting effect;

4. Skilled operators: The front hand is old, the thumbs of both hands are flat and wide, the gestures are correct when operating, the upper and the heel must be clamped.

5. The new body needs to use the front panel machine for trial production when printing the confirmation board. When there is no problem, it will be put into uniform size and turned to mass production; the front assistant must cooperate with the board maker to test the board, and repair the board to ensure the smooth progress of on-site production;

6. The good price and quality Intelligent automatic shoe production line is a production mode that cooperates with multiple departments, and the requirements are strict; the key is to cooperate closely with each production department. It is suggested that the group piece-rate model should be adopted in the original place of use to facilitate the progress of the process.