Good price and quality Intelligent automatic shoe production line does not have enough nails: This is a common failure of the nailing and tensioning machine. One of the reasons is that the nail feeding mechanism is not working properly, and the other is that the nail feeding groove and the nail divider are stuck. The resistance and the loss of nails are reduced. The nail feeding mechanism is a mechanical transmission with a complex and precise structure. The two nail lifting plates in the nail box move up and down alternately to send the nails from the nail box into the nail feeding groove. If the nail lifting plates are stuck, the nail feeding stops.

This is because the gap between the nail lifting plate and the slideway is too small or the nail lifting plate is stuck by scrap iron. At this time, all the nails in the nail box should be removed first, the nail lifting plate should be removed, the corrugated corners should be smoothed and demagnetized, and then put into the nail box and operated, and then loaded with nails after the operation is normal use. The nail feeding slot and the nail divider are blocked because the unqualified nails are stuck in the nail feeding slot so that other nails cannot pass through, or the nail splitter is stuck and cannot be rotated. At this time, the unqualified nails in the slot should be removed , remove the nail divider and take out the jammed nails or foreign objects. Only by using nails with good quality and consistent specifications can the specified number of nails be ensured.

good price and quality Intelligent automatic shoe production line Another point is that the nailing is not straight and there are high and low: the nails of the stretching machine are driven into the help foot at one time, and the nails are required to be straight, and the nail cap and the help foot must be flat. If the nail is crooked, it means that the clip mouth is faulty and should be repaired or replaced; if the nail cap is high or low, it means that the length of the nailing rod is inconsistent, and all the nailing rods should be removed and ground to the exact same length , and replace unqualified nail rods.